GARNIC RELEASES NEW
“GarBURN” STRIPPING SYSTEM
Garnic Technologies again proved themselves as leaders in environmentally
conscious & energy efficient stripping technology development.
The development is a result in general customer dissatisfaction
in the three types of stripping presently available, namely:
- Sand furnace
- “Burn out” Furnaces
- Chemical Tank dipping methods.
The NEW “GarBURN” Stripping System
strips jigs and fixtures using precisely controlled recirculated
air. The time to strip most jigs is reduced and allowing operators
to reduce accumulation and the need for backup jigs.
Because of the controlled, lower average burn-off temperature,
product reworks may are processed quickly without surface deterioration,
deformation or distortion.
The system is unique with the following features
& benefits
- Controlled temperature to burn the jigs or reworked product
means that minimal or no distortion due to the excessive
heat in the traditional sand and burn-off furnaces.
- The unique inbuilt heat exchanger means that we need only one
burner instead of the conventional two. The total energy saving
is around half of the conventional burn-off
furnaces
- High speed recirculated air actually wipes the jigs clean
of ash, ready for use at the end of the heat cycle.
- The burn-off chamber runs at negative pressure so leaks cannot
create an odour in the factory.
- There is no exposed ceramic fiber in the design. Conventional
furnaces deteriorate very quickly. The door seals cause odour
and reduced efficiency.
|
